Technical features

Type: SM 89-02
Size of vacuum pump: 115 x 60 x 60 mm
Weight: 0,15kg

Technical Features

Voltage: U1: 230V~50 Hz Power Consumption: 7W
U2: 120V~60 Hz Power Consumption: 6.5W
Power supply unit: AC 230 V/DC 3 V 500 mA
AC 120 V/DC 3 V 500 mA
Power supply unit made by: FUJIKON
Model: D35-03-500
Class protection against indirect contact:
II B type patient part

Continuous operation with intermittent duty
Loading time: 3 minutes
Spacing time: 1 minute
Degree of protection: IP20
Vacuum: -0.4 bar
Application temperature: between 0 and 40 °C
Storage temperature: between 0 and 40 °C

Fields of application of the device

Infants and young children are unable to blow their noses by themselves. With the help to the nose cleaning device you can keep the baby’s and young child’s nose thoroughly clear.

Using the device does not substitute doctor’s medical assistance. The device can also be operated with two 1,5 V AA batteries, which can be inserted by removing the cover at the bottom of the casing. Used batteries are environmentally harmful. Dispose them only at designated collection sites, do not throw away.

Using the nose cleaning device

We dispose the nose cleaner with two types of probe

• We recommend the probe head with the cone end for general use. With this device the nasal cavity can be cleaned thoroughly. Sit the baby up in your lap. Place the nose cleaning probe in one of the child’s nostrils. The join of the nostril and probe should be airtight and you should block the other nostril with your finger. If you place the probe into the nostril correctly, mucus should appear in the probe within a few seconds. You should perform this operation on both nostrils.

• The nose probe with the silicon tube with a collar is for suction of visible (fluid or clotted) mucus. Sit the baby up in your lap. Place the nose cleaning probe in the nostril in such a way that the end of the short silicon tube with the collar should reach into the mucus. The mucus will appear in the probe within a few seconds. You should perform this operation on both nostrils.

WARNING: The probe with the silicon tube with the collar must not be pushed all the way info the nostril, because it may cause discomfort to the baby, or might injure the nostril.

After successful nose cleaning you should cut the current off by turning it off, then unplugging the adapter form the socket. Pull the silicon tube attached to the pump off the suction stub. In case of fault or abnormal operation turn the device off and unplug the adapter from mains.

Cleaning the nose probe

Pull silicone tube off the nose probe. Wash both ends of the probe in a detergent solution, rinse thoroughly, then sterilize by boiling for 30 minutes.

Cleaning the vacuum pump

The outer casing of the vacuum pump should be cleaned with a cloth dampened with a detergent solution. Should milk inadvertently get in to the pump, it should be washed thoroughly as seen in the illustration.

Order of cleaning

1. Fill the silicone suction tube of the pump into the water.
2. Place the silicone suction tube of the pump into the water
3. Hold the device above the bowl
4. Turn on the device. It may be necessary to repeat this operation.

Guarantee: 2 years

Number of MEEI qualification:
E 0495 e 113, Hu-344

ORKI qualification number:
393/1992 Adequacy marking CE101